! Last configuration change at 06:30:23 UTC Mon May 15 2017 Vlan internal allocation policy ascending ! Last configuration change at 06:26:58 UTC Mon May 15 2017 Likewise, PC3 and VLAN10 will establish a healthy connection. When you ping from PC2 to PCs that are members of VLAN5, you can see that the process is successful. Check that the routing between VLANs is working properly. Now, ping the PC2 to the V2 member PC2 and test the connection. *Mar 1 00:09:18.259: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up In this step, open the command prompt by clicking R1 in the workspace to perform VLAN routing on a single cable on the Cisco Router and perform the following commands. Then, we have assigned the PCs to VLANs and made the Trunking connection. Up to this step, we have configured VPCS computers and created VLANs. VIOS-L2-01(config)#interface gigabitethernet 0/1 Use the following commands to perform the same operations on Cisco Layer 2 Switch-2. ![]() VIOS-L2-01(config)#interface gigabitethernet 0/0 VIOS-L2-01(config-if)#switchport mode trunk VIOS-L2-01(config-if)#switchport trunk encapsulation dot1q VIOS-L2-01(config)#interface gigabitethernet 0/3 VIOS-L2-01(config-if)#switchport access vlan 10 VIOS-L2-01(config)#interface gigabitethernet 0/2 ![]() VIOS-L2-01(config-if)#switchport access vlan 5 VIOS-L2-01(config-if)#switchport mode access vIOS-L2-01(config)#interface gigabitethernet 0/1 Use the following commands to determine the Access and Trunk interfaces of the Layer 2 Switch and to make PCs a member of VLANs. ![]() Configure the interfaces connected to the Cisco Router and L2 Switch as Trunk. You must configure the L2 Switch interfaces.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |